Brooks Brothers Logo Trailer
Red Horizontal Bar
 

14' Dump Trailer

Specifications Page | Back to Trailers Page

  


Model DT-142-7K shown


Model DT-142-7K shown

Standard Features


Twin Cylinder Scissor Hoist


Adjustable Hitch Plate


Self-Contained System w/Remote


  • 12,000 lbs. Load Capacity
  • 16,000 lbs. GVWR
  • 14’L x 81”W x 24”H Cargo Bed
  • Volume: 7 Cubic Yards
  • 50 Degree Dump Angle
  • 6’ Slide-Out Ramps
  • 60” Tongue Length
  • 102” Overall Width
  • 26” Deck Height
  • 7000# Tandem Dexter Axles
  • 8 Bolt Hubs
  • Electric Brakes on All Wheels
  • Slipper Spring Suspension
  • ST235/85R16 LR-G Tires
  • White Mod Wheels
  • Mud Flaps
  • 2 5/16” Ball Coupler or 2 1/2” Lunette Eye (Your Choice)
  • 6-Position Adjustable Hitch Plate
  • 3/8” Galvanized Safety Chains
  • 12000 lb. Drop Leg Jack
  • 7” Channel Tongue
  • 8” C-Channel Main Frame
  • 3” Channel Crossmembers on Approx 16” Centers
  • Cargo Bed: 12 Gauge Steel Construction
  • (4) 5/8” D-Rings, Floor Mounted (1) one each Corner
  • Brackets for Roll-Up Tarp and 1/2" Tie-Off Rail on Three Sides
  • Double Rear Gates with Cam Lock
  • Enclosed & Lockable Pump & Reservoir Tank with Filter
  • 12 Volt Deep Cycle Battery Mounted at Front of Bed
  • Power Up Hydraulics
  • T-10 Scissor Hoist with Twin Lift Cylinders (10 Ton)
  • Wire and Wireless Remote Controls
  • ICC & DOT Approved Lights
  • Sealed Beam Rubber Mounted Lights
  • S.O. Cable Wiring Loom
  • Wiring Loom Terminated in Junction Boxes
  • Connections Soldered & Sealed with Heat Shrink Tubing
  • 32” Pigtail w/ 6-Way Aluminum Die Cast Plug
  • Breakaway Kit with Trickle Charger
  • Trailer is Completely Sandblasted
  • Seams are Sealed with Paintable Caulk
  • Rust Prohibitive Two-Part Epoxy Polyamide Primer
  • Two-Part Acrylic Polyurethane Topcoats
  • 2” Red/White Reflective Tape

    Also Available:

  • Gas Powered Engine


Double Rear Gates
with Cam Lock


6' Foot Slide-Out Ramps

Brooks Brothers Trailers is a proud member of the National Association of Trailer Manufacturers

Brooks Brothers Trailers a Division of MORAN WELDING, INC

  

Home | Trailers | Parts & Service | Sales | Contact Us | Map/Directions | Printable Flyers | Find a Dealer

sales@brooksbrotherstrailers.com

©2006 Brooks Brothers Trailers. All rights reserved.

Web site design by designsby.us