DT142

Dump Trailer

CAPACITY

• 12,000 lbs. Load Capacity
• Approx. 4,000 lbs. Curb Weight
• 16,000 lbs. GVWR (Calculated at 15% Tongue Weight)

DIMENSIONS

• 14'L x 81"W x 24"H Cargo Bed
• Volume: 7 Cubic Yards
• 50 Degree Dump Angle
• 60" Tongue Length
• 102" Overall Width
• 26" Deck Height

AXLES

• 7,000 lb. Tandem Dexter Axles
• 8 Bolt Hubs
• 12" x 2" Electric Brakes on All Wheels
• Slipper Spring Suspension
• (4) four - LT235/85R16 LR-G Tires
• (4) four - 16" x6" Single White Mod Wheels (8 Hole on 6 1/2" Bolt Circle)
• (1) Pair - Mud Flaps

LOADING RAMPS

• 66"L x 17"W Slide-Out Adjustable Width Ramps
• Ramps Store under Cargo Bed at Rear

TONGUE HITCH & JACK

• 7" C-Channel Upper Tongue
• 5" C-Channel Lower Tongue
• 2 5/16" Ball Coupler or 2 1/2" Lunette Eye (Your Choice)
• 6-Position Adjustable Hitch Plate (21" through 33")
• 3/8" Galvanized Safety Chains with Safety Latch Hooks and Anchor Shackle
• Single, 12,000 lb. Drop Leg Jack

MAIN FRAME

• 8" C-Channel Main Frame
• 3" Channel Crossmembers on Approx. 16" Centers
• (2) Full Length 5" C-Channel Scissor Hoist Frame

CARGO BED

• Floor: 12 Gauge Smooth Steel Construction
• Sidewalls: 12 Gauge Smooth Steel Construction
• Tailgate: Split Swing Open Gates with Cam Lock
• (4) four - 5/8" D-Rings, 19,000 lbs. Capacity each, Floor Mounted (1) one each Corner
• Fabricated 1/8" Steel Diamond Tread Plate Fender Construction

HYDRAULIC SYSTEM

• Enclosed & Lockable Hydraulic Pump Motor with Reservoir Tank with Filter
• 12 Volt Deep Cycle Battery Mounted at Front of Bed
• Power Up Hydraulics
• T-10 Scissor Hoist with Twin Lift Cylinders
• Wired and Wireless Remote Controls

12 VOLT WIRING SYSTEM

• ICC & DOT Approved Lights
• Sealed Beam Rubber Mounted Stop, Turn, Tail and Marker Lights
• S.O. Cable Wiring Loom, Clamped on 16" Centers with Rubber Lined Clamps
• Wiring Loom Terminated in Junction Boxes
• Connections Soldered and Sealed with Heat Shrink Tubing
• 32" Pigtail w/6-Way Aluminum Die Cast Plug, Terminated at Junction Box
• Breakaway Kit, with Sealed Lead Acid Battery & Trickle Charger

PAINT

• Trailer is Completely Sandblasted
• Seams are Sealed with Paintable Caulk
• Rust Prohibitive Two-Part Epoxy Polyamide Primer
• Two-Part Acrylic Polyurethane Topcoats (Standard Colors: Black & White)
• All Attachments Painted before Assembly and Installed with Serviceable Fasteners
• 2" Red/White Reflective Tape on Both Sides of Trailer